Augmentation

Although the travel time of a satellite signal to Earth is only a fraction of a second, much can happen to it in that interval. For example, electrically charged particles in the ionosphere and density variations in the troposphere may act to slow and distort satellite signals. These influences can translate into positional errors for GPS users—a problem that can be compounded by timing errors in GPS receiver clocks. Further errors may be introduced by relativistic time dilations, a phenomenon in which a satellite’s clock and a receiver’s clock, located in different gravitational fields and traveling at different velocities, tick at different rates. Finally, the single greatest source of error to users of the Navstar system is the lower accuracy of the civilian C/A-code pulse. However, various augmentation methods exist for improving the accuracy of both the military and the civilian systems.

When positional information is required with pinpoint precision, users can take advantage of differential GPS techniques. Differential navigation employs a stationary “base station” that sits at a known position on the ground and continuously monitors the signals being broadcast by GPS satellites in its view. It then computes and broadcasts real-time navigation corrections to nearby roving receivers. Each roving receiver, in effect, subtracts its position solution from the base station’s solution, thus eliminating any statistical errors common to the two. The U.S. Coast Guard maintains a network of such base stations and transmits corrections over radio beacons covering most of the United States. Other differential corrections are encoded within the normal broadcasts of commercial radio stations. Farmers receiving these broadcasts have been able to direct their field equipment with great accuracy, making precision farming a common term in agriculture.

Another GPS augmentation technique uses the carrier waves that convey the satellites’ navigation pulses to Earth. Because the length of the carrier wave is more than 1,000 times shorter than the basic navigation pulses, this “carrier-aided” approach, under the right circumstances, can reduce navigation errors to less than 1 cm (0.4 inch). The dramatically improved accuracy stems primarily from the shorter length and much greater numbers of carrier waves impinging on the receiver’s antenna each second.

Yet another augmentation technique is known as geosynchronous overlays. Geosynchronous overlays employ GPS payloads “piggybacked” aboard commercial communication satellites that are placed in geostationary orbit some 35,000 km (22,000 miles) above Earth. These relatively small payloads broadcast civilian C/A-code pulse trains to ground-based users. The U.S. government is enlarging the Navstar constellation with geosynchronous overlays to achieve improved coverage, accuracy, and survivability. Both the European Union and Japan are installing their own geosynchronous overlays.

The Navstar system

The Navstar GPS system consists of three major segments: the space segment, the control segment, and the user segment. The space component is made up of the Navstar constellation in orbit around Earth. The first satellite was an experimental Block I model launched in 1978. Nine more of these developmental satellites followed over the next decade, and 23 heavier and more-capable Block II production models were sent into space from 1989 to 1993. The launch of the 24th Block II satellite in 1994 completed the GPS constellation, which now consists of two dozen Block II satellites (plus three spares orbiting in reserve) marching in single file in six circular orbits around Earth. The orbits are arranged so that at least five satellites are in view from most points on Earth at all times. Since 1994, newer versions of Block II satellites have been launched to replace older models. The first satellite of Block III was launched in 2018. Ten Block III satellites were planned with the final launch scheduled for 2023.

A typical Block II satellite weighs approximately 900 kg (2,000 pounds) and, with its solar panels extended, is about 17 metres (56 feet) across. Its key elements are the winglike solar arrays that generate electrical power from sunlight, the 12 helical antennas that transmit navigation pulses to users on the ground, and its long, spearlike radio antenna that picks up instructions from control engineers. As a satellite coasts through its 12-hour orbit, its main body pivots continuously and the solar arrays swivel, keeping its navigation antennas pointing toward Earth’s centre and its solar arrays aligned perpendicular to the Sun’s rays.

The control segment consists of one Master Control Station at a U.S. Air Force base in Colorado and four additional uncrewed monitoring stations positioned around the world—Hawaii and Kwajalein Atoll in the Pacific Ocean, Diego Garcia in the Indian Ocean, and Ascension Island in the Atlantic Ocean. Each monitoring station tracks all of the GPS satellites in its view to check for orbital changes. Variations in satellite orbits are caused by gravitational pulls from the Moon and Sun, the nonspherical shape of Earth, and the pressure of solar radiation. This information is processed at the Master Control Station, and corrected orbital information is quickly relayed back to the satellites via large ground antennas. Every 18 months on average, the satellites within a given ring drift too far from their original configuration and must be nudged back with onboard thrusters fired by ground control.

The user segment consists of the millions of GPS receivers that pick up and decode the satellite signals. Hundreds of different types of GPS receivers are in use; some are designed for installation in automobiles, trucks, submarines, ships, aircraft, and orbiting satellites, whereas smaller models have been developed for personal navigation.