bloom

…usable product, known as a bloom, may have weighed up to 10 lbs (5 kg). Repeated reheating and hot hammering eliminated much of the slag, creating wrought iron, a much better product. By the 15th century, many bloomeries used low shaft furnaces with waterpower to drive the bellows, and the…

…of metal known as a bloom. This may have weighed up to 5 kilograms (11 pounds) and consisted of almost pure iron with some entrapped slag and pieces of charcoal. The manufacture of iron artifacts then required a shaping operation, which involved heating blooms in a fire and hammering the…

…spongy ball of iron—called a bloom—was produced in the bottom of the furnace. This was extracted by breaking open the furnace, and then it was hammered into bars of wrought iron, which could be shaped as required by further heating and hammering. Apart from its greater abundance, iron for most…

…products are made of either blooms or billets, which are, like slabs, considered a semifinished product and are cast by a continuous caster or rolled at a blooming mill. Billets have a cross section 50 to 125 millimetres square, and blooms are 125 to 400 millimetres square. In practice, they…

Cast ingots, sometimes still hot, arrive at slabbing and blooming mills on railroad cars and are charged upright by a special crane into under-floor soaking pits. These are gas-fired rectangular chambers, about 5 metres deep, in which four to eight ingots are simultaneously heated…