Comparison with molecules
- Key People:
- Sir Harold W. Kroto
- Robert Curl
The manner in which clusters differ from molecules is more of a categorical nature than one of physical properties. Molecules have a definite composition and geometry; with few exceptions clusters can be made of any number of particles and may have any of several geometries. The four possible structures of a cluster of seven argon atoms are shown in , and the lowest and next three higher-energy structures of a 13-atom cluster of argon are illustrated in . The 13-atom cluster has the form of a regular icosahedron of 12 argon atoms around a central atom and is particularly stable.
Despite their multiplicity of structures, small clusters of fixed size, undergoing vibrations of small amplitude around a single geometry, are in most respects indistinguishable from molecules. If such clusters are given energy that is not great enough in magnitude to break them into separate parts, they may assume other geometries, alternating among these structural forms. This phenomenon is rarely seen with conventional molecules, but it is not unknown for energized molecules to exhibit more than one structure and to pass among them.
All in all, small clusters are much like molecules and are often considered to be molecules, while very large clusters are quite similar to bulk matter. The properties of clusters whose size is between these extremes may be like either or like neither.
Methods of study
Clusters can be studied by experiment, by theoretical analysis, and by simulation with computer-generated models. For several reasons they cannot be studied in the same manner as bulk matter. First, if individual clusters are allowed to coalesce into a mass, they will actually turn into bulk matter, so they must be kept separated. Second, it is desirable (but not always possible) to conduct experiments that distinguish the size and structure of each kind of cluster under observation. Because of these two considerations, experiments with clusters are usually more difficult than those with either specific molecules or bulk matter. Most of the difficulties arise from the same properties that make clusters interesting: the ease with which their sizes and compositions are varied and the variety of structures available for clusters of almost any given size.
Preparation of clusters
Because of these difficulties, most experiments on clusters have been carried out with the clusters isolated in the gas phase; a few studies have been done with them in solution or in frozen matrices. Clusters can be prepared in the gas phase and then either studied in that form or captured into solvents or matrices or onto surfaces. They may be made by condensation of atoms or molecules or by direct blasting of matter from solids. In the most generally used method, a gas containing the gaseous cluster material is cooled by passing it under high pressure through a fine hole or slot. The expansion cools the gas rapidly from its initial temperature—usually room temperature but much higher if the cluster material is solid at room temperature—to a temperature not far above absolute zero. If, for example, argon gas is expanded in this way, it condenses into clusters if the pressure is not too high and the aperture is not too small; if the conditions are too extreme, the argon instead turns to snow and condenses.
Inert gases are often used as the medium by which other materials, in a gaseous or vaporous state, are transported from the ovens or other sources where they have been gasified and through the jets that cool them and turn them into clusters. One especially popular and interesting method in which solids are vaporized is by the action of intense laser beams on solid surfaces. Often called ablation, this process is an effective means of vaporizing even highly refractory materials like solid carbon. The ablated material is then carried through the cooling jet by an inert gas such as helium or argon.
Ionization and sorting of clusters
Once the clusters have been formed, they can be studied in a variety of ways. One of the first techniques was simply to ionize the clusters, either with ultraviolet radiation (usually from a laser) or by electron impact. The gaseous ionized clusters are accelerated by an electric field and then analyzed according to their masses (see mass spectrometry); these results immediately reveal the number of atoms or molecules in the cluster. The analysis yields the distribution of the relative abundances of clusters of different sizes in the beam. If the experiment is done with considerable care, the abundance distribution corresponds to the true relative stabilities of the clusters of different sizes. However, like many experiments with clusters, these can either provide results consistent with the equilibrium conditions that reflect those relative stabilities, or they can give results that reflect the rates of the cluster-forming processes rather than the equilibrium characteristics, as the latter may take far longer to reach than the time required to form clusters. Some of the implications of the abundances found in such experiments are discussed below in the section Structure and properties: Structure.
Because of the conditions under which clusters are formed, their distributions contain many different sizes and, in some instances, different shapes. Because chemists seek to characterize clusters of a single size and geometry, the clusters must first be sorted on that basis. If the clusters carry charge, they can be separated according to size with a mass spectrometer that sorts charged particles with approximately the same energy according to their masses. This is usually done by deflecting the charged clusters or ions with an electric or magnetic field; the smaller the mass, the greater is the deflection. This is one of the most effective ways of preparing a beam of clusters of only a single selected mass. It does not eliminate the problem of multiple structures, however.
A technique that can sometimes be used to sort clusters according to their size and structure is a two-step process in which one cluster species at a time is excited with the light from a laser and is then ionized with light from a second laser. This process, called resonant two-photon ionization, is highly selective if the clusters being separated have moderately different absorption spectra. Since this is frequently the case, the method is quite powerful. As the experimenter varies the wavelength of the first exciting laser, a spectrum is produced that includes those wavelengths of light that excite the cluster. If the wavelength of the second ionizing laser is varied, the method also yields the ionization potential, which is the minimum energy that the photon in the ionizing beam must possess in order to knock an electron out of the cluster. Such data help to reveal the forces that bind the cluster together and give some indication of how the cluster will react with atoms, molecules, or other clusters.
Computer simulation of cluster behaviour
A powerful tool for studying clusters is computer simulation of their behaviour. If the nature of the forces between the individual atoms or molecules in a cluster is known, then one can construct a computer model that represents the behaviour of those atoms or molecules by solving the equations of motion of the cluster. To describe the cluster in terms of classical mechanics, the Newtonian equations of motion are solved repeatedly—namely, force equals mass times acceleration, in which the forces depend on the instantaneous positions of all the particles. Hence, these equations are simultaneous, interlinked equations; there is one set of three (for the three instantaneous coordinates of each particle) for each atom or molecule. The results can take one of three forms: (1) the positions and coordinates of the atoms, given in tables, (2) the average properties of the entire cluster, or (3) animations. Tables are too cumbersome for most purposes, and specific average properties are frequently what the investigator seeks. Animated sequences show the same content as the tables but far more efficiently than extensive tables do. In fact, animations sometimes reveal considerably more than is expected by scientists.
It is also possible to construct computer models of clusters based on quantum mechanics instead of Newton’s classical mechanics. This is especially appropriate for clusters of hydrogen and helium, because the small masses of their constituent atoms make them very quantumlike in the sense that they reveal the wavelike character that all matter exhibits according to quantum mechanics. The same kinds of data and inferences can be extracted from quantum mechanical calculations as from classical ones, but the preparation and visualization of animations for such clusters are much more demanding than their classical mechanical counterparts.