Isolation and identification of isoprenoids

Purification

Isoprenoids can be purified by various techniques that depend primarily on the physical properties of the compound, such as the melting point or the boiling point or solubilities in various other substances. The chemical properties may be an advantage or a disadvantage in the application of these methods. For example, a compound in which heating induces a chemical reaction would be destroyed rather than be purified by a procedure requiring the application of heat, such as distillation or sublimation. On the other hand, methods depending on physical properties often cannot effect a satisfactory separation of a mixture of compounds possessing very similar physical properties; sometimes such mixtures can be converted by chemical treatment into a mixture of new substances that can be more readily separated; the separated components may then be reconverted into the original compounds.

In general, solid compounds can be purified by recrystallization and volatile compounds (either solid or liquid) by distillation. Nonvolatile liquids or solids contaminated by very similar substances can be purified by chromatography. Because even small amounts of contaminants can give rise to seriously misleading results in chemical identification, purification of a compound for this purpose must be carried to the highest attainable degree; it is highly desirable to subject a substance to a succession of purification procedures based upon different principles, such as distillation and crystallization. The rigour of this requirement is far higher than in purifying a substance to make it suitable for typical practical applications, for which it is often sufficient only to remove components that would be objectionable in the intended application (e.g., those that impart unwanted odour, colour, or flavour).

Analysis and determination of isoprenoid structure

Determination of the elemental composition of isoprenoids seldom presents difficulty, because they are hydrocarbons, and a simple, reliable procedure for quantitative analysis of carbon and hydrogen has been available since the early 19th century. The only other element commonly present in isoprenoids is oxygen, which does not interfere with the analysis for carbon and hydrogen, although it is difficult to determine directly; usually it is assumed to constitute the proportion of the compound not accounted for as carbon, hydrogen, and any other elements that have been measured.

Assignment of structures to isoprenoids once presented a challenging problem because the method for determining the structure of an organic compound was based entirely on studies of chemical reactions. Sequences of reactions eventually led to compounds with known structures, and the path back to the original substance was inferred from knowledge of the structural changes associated with the reactions employed. Frequently, more than one structure would be considered consistent with the information available. One of the most difficult isoprenoids to identify was camphor, for which more than 30 different structures were proposed before the correct one (shown here) was established.

The technique most commonly used to determine the structure of an organic compound relies on the effects of a magnetic field. This technique, called nuclear magnetic resonance (NMR), was developed in the latter half of the 20th century by Swiss physical chemist Richard R. Ernst. In NMR a sample is dissolved and placed in a thin tube, which is spun between the poles of a powerful magnet. Radio-frequency energy is superimposed on the magnetic field, and the response of the compound to this energy is collected and interpreted. Because broad ranges of energy can be utilized and the complex results computer-analyzed, detailed assignments of the environment and of the relative position of hydrogen atoms and carbon atoms can be made.

Other valuable physical techniques used in structural determination include mass spectrometry, X-rays, and patterns of absorption of light energy, such as ultraviolet absorption spectrums or the absorption of infrared energy. High-resolution mass spectrometry enables the exact chemical formula of a compound to be determined. X-ray crystallography permits the detailed spatial location of each atom to be determined from a diffraction pattern. Once a compound has been crystallized, it is a routine task to obtain a detailed X-ray structure. In the past, synthesis was carried out to conform a deduced structure, but modern analytical methods have eliminated the need for synthesis to fulfill this role. On the other hand, chemical synthesis is useful for producing scaled-up amounts of material that are in short supply from their natural sources. Of course, in order to carry out the synthesis, the detailed structure must first be known.

Biosynthesis of isoprenoids

By the late 1940s the ubiquity of the five-carbon isoprene unit had been recognized for a long time. However, the identity of the compounds actually involved in the physiological assembly of the isoprenoids was not known, although it had been suggested that they were somehow built up from acetic acid, which contains only two carbon atoms per molecule. During the 1950s, German-born American biochemist Konrad E. Bloch and German biochemist Feodor Lynen discovered that the synthesis of isoprenoids in nature indeed begins with acetyl coenzyme A (sometimes called activated acetate), a compound derived from acetic acid and coenzyme A (CoA), a complex substance that participates in many reactions that are controlled by enzymes. Previously unknown compounds, mevalonic acid and isopentenyl pyrophosphate (IPPP), occur as important intermediates in the process.

The formation of geranyl pyrophosphate, the precursor of the monoterpenes, from two molecules of IPPP requires that one of them be transformed to dimethylallyl pyrophosphate (DMAPP). In the equations below, only the covalent bonds of the carbon skeletons are shown, and PP stands for the pyrophosphate group.

A similar reaction of geranyl pyrophosphate with IPPP leads to the 15-carbon compound farnesyl pyrophosphate—from which the sesquiterpenes are derived—which in turn is converted to the 20-carbon precursor of the diterpenes. All these reactions produce substances in which the isoprene units are joined head-to-tail; many of the larger isoprenoid molecules (triterpenes and tetraterpenes) are not built up by further incorporation of IPPP units but by tail-to-tail coupling of 15- or 20-carbon compounds. The structure of squalene, a triterpene, illustrates this point. The tetraterpene carotenoids apparently arise from a similar reaction of two 20-carbon isoprenoids.