- Also called:
- lorry
- Key People:
- Arthur William Sidney Herrington
- Related Topics:
- fire engine
- industrial truck
- DUKW
- Tesla Cybertruck
- fifth wheel
News •
Although pneumatic tires appeared on automobiles as early as 1904, large trucks were equipped with hard rubber tires until World War I. Cotton was replaced by synthetics in the carcass of truck tires in the 1930s, with steel wire and fibreglass plies appearing later. Recent developments include the use of a single wide tire to carry the same load as a dual wheel. Tire chains first became available in 1904 and knobby snow tires by 1936. To reduce costs, many trucking firms use recapped tires, extending the life of the carcass about two and a half times. In 1955 tubeless tires became available in large truck sizes.
Transmissions
Automatic transmissions for trucks have been available since the 1950s. For some diesels it is necessary to operate the engine within a relatively narrow speed range. This requires a large number of forward speeds, with some units having as many as 18 speeds.
Brakes
The first truck brakes were brake shoes operating directly on the wheels. From this simple beginning has evolved one of the most complex braking systems found on any type of vehicle. The first air brakes were introduced in 1918. Seven years later four-wheel brakes were introduced on trucks, and the internally expanding type was introduced by 1930. In the late 1930s the vacuum booster, or hydraulic brake, was introduced. In electric brake systems a floating armature contacts a rotating disk on the wheel when electric current is applied and through a cam arrangement applies the shoes to the drums. Air-over-hydraulic brakes also are used in some vehicles.
Of these methods of application, air is the most widely used. The engine-driven compressor supplies air at a nominal pressure, regulated by an air governor. Air pressure is indicated by a pressure gauge and a low-pressure warning device, either audible or visual. Air is stored in the reservoirs and supplied to the brake valves; a foot valve supplies air to all brake chambers on the vehicle, including those being towed. Another brake valve is hand-controlled and applies the brakes on the towed vehicle only. Both the foot pedal and hand valve supply air to the same service line, which extends back to the towed vehicles. The second, or emergency, line carries full air pressure when the vehicle is in operation. If this line is broken, the emergency brakes are applied on all towed vehicles from air reservoirs located on the towed vehicles. After reaching the brake chamber from the brake valves, the air acts on a diaphragm connected to a push rod, which in turn actuates a cam or wedge that moves the shoes against the brake drum. Other emergency brake application systems utilize the parking brake circuitry and a mechanical spring to keep the brakes engaged in the event of air pressure loss. These are operated by controls in the truck cab.
Noise control
Modern trucks are easily recognized as a source of noise pollution. The major sources of noise, in decreasing significance, are tire-road contact, engine exhaust, and cooling ducts and fans. The decibel level of each may be reduced by changing tire-tread designs and highway surfaces, by improving exhaust muffler efficiency and shielding the engine with more absorbent materials, and by changing fan blade and engine enclosure designs. The U.S. Society of Automotive Engineers (SAE), which sets a wide variety of test procedures for motor vehicles, has developed standard tests for measuring noise levels, and many different federal, state, and local authorities in the United States have enacted 80-decibel noise limits based on SAE tests. Similar regulations exist within the European Union.