- Related Topics:
- ice
- Heinrich event
- ice island
- On the Web:
- Roger Williams University Open Publishing - Introduction to Oceanography - Iceberg (Nov. 08, 2024)
Most of the erosion taking place on Antarctic icebergs occurs after the bergs have emerged into the open Southern Ocean. Melt and percolation through the weak firn layer bring most of the freeboard volume to the melting point. This allows ocean wave action around the edges to penetrate the freeboard portion of the berg. Erosion occurs both mechanically and through the enhanced transport of heat from ocean turbulence. The result is a wave cut that can penetrate for several metres into the berg. The snow and firn above it may collapse to create a growler (a floating block about the size of a grand piano) or a bergy bit (a larger block about the size of a small house). At the same time, the turbulence level is enhanced around existing irregularities such as cracks and crevasses. Waves eat their way into these features, causing cracks to grow into caves whose unsupported roofs may also collapse. Through these processes, the iceberg can evolve into a drydock or a pinnacled berg. (Both types are composed of apparently independent freeboard elements that are linked below the waterline.) Such a berg may look like a megalithic stone circle with shallow water in the centre.
In the case of Arctic icebergs, which often suffer from repeated capsizes, there is no special layer of weak material. Instead, the whole berg gradually melts at a rate dependent on the salinity (the salt concentration present in a volume of water) and temperature at various depths in the water column and on the velocity of the berg relative to the water near the surface.
On the basis of their observations of iceberg deterioration, American researchers W.F. Weeks and Malcolm Mellor have proposed a rough formula for predicting melt loss: –Z = K D, where Z = loss in metres per day from the walls and bottom of the iceberg, K = a constant of order 0.12, and D = mean water temperature in °C averaged over the draft of the iceberg. This yields a loss of 120 metres (400 feet) from iceberg sides and bottom during 100 days of drift in water at 10 °C (50 °F)—a rate that corresponds quite well to survival times of icebergs in waters off the coast of Newfoundland as measured by the International Ice Patrol. It has been suggested that if the melt rate could be reduced by interposing a layer of fabric between the ice and water, an iceberg could theoretically survive long enough to be towed across the Atlantic Ocean from Newfoundland to Spain for use as a water and power source.
In Arctic icebergs, erosion often leads to a loss of stability and capsizing. For an Antarctic tabular berg, complete capsize is uncommon, though tiltmeter measurements have shown that some long, narrow bergs may roll completely over a very long period. More common is a shift to a new position of stability, which creates a new waterline for wave erosion. When tabular icebergs finally fragment into smaller pieces, these smaller individual bergs melt faster, because a larger proportion of their surface relative to volume is exposed to the water.